Open Forum

Base Linearization in Fiery

  • 1.  Base Linearization in Fiery

    Posted 02-23-2018 07:46 AM
    Hello,

    We recently purchased a Xerox V180 with a Fiery Print server. I'm new to the Fiery and want to perform a base Linearization to G7 specs before I create any profiles. Where can I do that in a Fiery printer server?

    Thank you!

    ------------------------------
    Mitchell Vaughan
    ------------------------------


  • 2.  RE: Base Linearization in Fiery

    Posted 02-25-2018 09:40 AM
    Good morning Mitchell,

    So there are a couple ways to do this.

    1. I think within Fiery 6 there is an option to use the G7 methodology when creating your calibration. You would have to speak to your EFI rep to find that out.

    2. You could use the Graphics arts package within the fiery front end to import a G7 curve after your calibration.

    3. Or you could use the TC1617 chart when building your profiles to make sure that the gray balance is taken into consideration fully when building the actual profile.

    To me, so long as the calibration will always get you back to the same place (stake in the ground), you can color manage outside of that and have consistent results.

    Thank you for the great question!

    Cory Sawatzki

    Director of Digital Print Technology | USA | Canada 

    CGS Publishing Technologies International LLC.



    ------------------------------
    Cory Sawatzki
    Director- Digital Printing Technology
    CGS Publishing Technologies Intl.
    Minneapolis MN
    (612) 455-8911
    ------------------------------