Edward, that target (IT874R 3x) was designed for the iSis and DTP70. To measure it on an i1iO in i1Profiler, you will have to go into patch mode, which is very slow but should work if you are desperate.
There is no i1iO reference file for that target but I am attaching the original IT874R 3x iSis.txt file which gives you CMYK percentages. Also to be safe, I'm attaching the visual version, IT874V 3x iSis.txt.
In i1Profiler, use the "Measure Chart" option and set up a custom layout of 49 x 33, then join the measurements to the CMYK values in Excel.
You may have to switch to 33 x 49 and experiment a bit to get the right patch values.
Good luck!
------------------------------
Don Hutcheson
HutchColor, LLC
Washington NJ
908-500-0341
don@...------------------------------
Original Message:
Sent: 07-16-2018 01:17 AM
From: Edward Duwariti
Subject: IT8 7.4/2005 For Target in G7 Calibration Forms
Hi guys,
I am looking for the Reference File for i1Profiler (i1Proi1IO) for the IT8 7.4 /2005 that is seen in the G7 Calibration Forms. This has 49 rows and 33 columns, not the new TC1617 target but the old IT8 7.4/2005 target that is found in these G7 forms.
The Reference Chart can be a delimited txt file or any format that i1Profiler understands
Please find this said image attached.
I am in the middle of collecting G7 samples for a new G7 master printer I am trying to certify. Hope somebody can be of help.
Thanks
Edward Duwariti
G7 Expert
NTC Services
------------------------------
Edward Duwariti
NTC Mexico
Mexico D.F.
+525552028047
------------------------------